Brad Nelson
Administrator
עַבְדְּךָ֔ אֶת־ הַתְּשׁוּעָ֥ה הַגְּדֹלָ֖ה הַזֹּ֑את
Posts: 12,261
|
Post by Brad Nelson on Aug 5, 2019 15:12:02 GMT -8
A friend told me that someone (Philips, in this case) had come out with a 4 ft. T12 LED replacement that didn’t require taking out the old ballast. I was hoping someone would come out with something like this. I read online about some caveats. Did I have the right kind of ballast? Well, these are good for both magnetic and electronic ballasts. (From what I can tell, earlier versions may not have supported both). I figure I’m covered there. Were they shunted or non-shunted? Being a conservative, I figure mine had to be non-shunted. The reverse didn’t sound very good. But I wasn’t able to tell by looking at them despite the video. The relevant parts in my light fixtures are hidden. But what the hell. They were only $8.80 a piece at Home Depot (the definitely shunted-friendly company). The investment would be minimal. So I bought a couple and they worked just fine. I bought the daylight (6500K) version. They seem put out about the same amount of light as the fluorescents, minus the flickering. And no mercury. About 1/2 the energy. (When they say “Up to 60%” I figure that’s what they mean.) 40-Watt Equivalent 4 ft. Linear T12 InstantFit LED Tube Light Bulb Daylight Deluxe (6500K)
|
|
|
Post by timothylane on Aug 5, 2019 15:20:14 GMT -8
You're talking lights that are four feet long? That seems an awful lot. We certainly had some long lights at our house (which were hard to deal with up there in the ceiling, so over time they ceased functioning well or at all), which of course were flourescent bulbs. I don't know if they were that long.
Maybe they could use them here. The bathroom light in my room doesn't work. I have no idea how big it is, never having even gotten close to it, but I've seen maintenance bring in possible replacements. We suspect there's an electrical problem, but getting anything down about it seems impossible. Part of the problem may be that it's only used to empty urinals into the toilet or get water from the sink for some grooming purposes. (They have showers elsewhere that can handle special wheelchairs and beds.)
|
|
Brad Nelson
Administrator
עַבְדְּךָ֔ אֶת־ הַתְּשׁוּעָ֥ה הַגְּדֹלָ֖ה הַזֹּ֑את
Posts: 12,261
|
Post by Brad Nelson on Aug 5, 2019 15:32:46 GMT -8
Roughly, the 40-Watt fluorescents are $2.83 per bulb (Philips/Home Depot). The cost of the LEDs are, to my mind, within reason for replacing old fluorescent bulbs as they go bad. These might become cheaper as time goes on and then a wholesale swap could be in order.
|
|